Table of Contents
Advertisement
1.
Download the
CALIBRATION
2.
Extract the files to your computer's hard drive.
3.
Navigate to the file location and copy the appropriate Nozzle Offset Calibration file to
your USB mass storage device.
NOTE: The Nozzle Offset Calibration files are specific for the model printer
(CubePro Duo or CubePro Trio) and for the material type (ABS or PLA)
currently installed in the printer.
4.
Insert the mass storage device into the CubePro USB inlet port and select PRINT.
5.
Navigate to the calibration file and select PRINT.
NOTE: The printer may require you to install additional cartridges or replace
a cartridge. Follow the instructions on the screen and refer to the section
titled
FILES.
Replacing A Material
Cartridge.
Advertisement
Table of Contents
Need help?
Do you have a question about the CubePro and is the answer not in the manual?
Questions and answers