Table of Contents
Advertisement
11.
Once completed, select the
12.
Properly remove the material cartridges.
NOTE: For more information, refer to the section titled Replacing a Material
Cartridge in the user guide.
13.
Power off the printer and disconnect it from utility power.
CAUTION: The printer must be powered off and the power cord must be
disconnected from utility power.
14.
Remove the lid from the top of the printer.
15.
Disconnect the cables
checkmark
to exit the utility.
X1
(A),
X2 (A)
and
X3 (A)
from extruder motors.
Advertisement
Table of Contents
Need help?
Do you have a question about the CubePro and is the answer not in the manual?
Questions and answers