Download Print this page

3D Systems CubePro Replacement Manual page 14

Print jet and extruder replacement

Hide thumbs Also See for CubePro:

Table of Contents

Select the upper right corner of the triangle on the touchscreen display.

NOTE: The printheads will move to the right rear corner of the print pad.

Using the designated page from the Setup/Repack instructions, slide the paper

between the print jets and the print pad.

NOTE: If there is a slight resistance, proceed to step 5.

NOTE: The red line (C) illustrates the gap between the print jets (A) and the

print pad (B).

If the paper slides easily between the print jets and print pad, rotate the adjustment

Table of Contents

Need help?

Do you have a question about the CubePro and is the answer not in the manual?