Table of Contents
Advertisement
1. INTRODUCTION
Read this manual carefully. It provides important safety infor-
mation to the Technician regarding the operations indicated
in this document.
Keep this Manual in a safe place. If you lose it, you can ask the
Manufacturer for another copy.
The Manufacturer of the appliance cannot be held responsi-
ble for any damage caused due to the non-observance of the
requirements listed in this manual.
Before carrying out operations on the machine,
read the instructions contained in this publica-
tion and follow the guidelines carefully. Keep this
manual and all attached publications in an accessible and
secure place.
This document assumes that the machine is installed in a lo-
cation where the current work safety and hygiene standards
are observed.
The instructions, drawings and documentation contained in
this Manual are technical and confidential. They are the sole
property of the Manufacturer, and may not be fully or par-
tially reproduced in any way.
The Manufacturer reserves the right to make any improve-
ments and/or modifications to the product. We guarantee
that this Manual reflects the technical state of the appliance
at the time it was released to the market.
We encourage the Technicians to make any proposals in re-
gards to improving the product or its Manual.
1.1 Guidelines for reading the Manual
This Manual is divided into separate chapters. The chapter
order is linked to the temporal logic of the life of the machine.
Terms, abbreviations and pictograms are used to facilitate
the immediate understanding of the text.
This Manual consists of cover, index and series of chapters.
Each chapter is sequentially numbered. The page number is
shown in the footer.
The machine identification data is displayed on the machine's
nameplate and the EU declaration of Conformity, whilst the
date and revision of the Instruction Manual is provided on
the last page.
Abbreviations
=
Section
Sec.
=
Chapter
Chap.
Para.
=
Paragraph
P.
=
Page
Fig.
= Figure
Tab.
=
Table
Units of measurement
The units of measurement are those provided by the Interna-
tional System (SI).
TECHNICIANS' manual
1.2 Storing the Manual
The Instruction Manual must be stored carefully. The manual
should be stored, handled with care with clean hands and not
placed on dirty surfaces. The Manual must be stored in an
environment protected from moisture and heat.
Do not remove, tear or arbitrarily modify any of its parts.
On the Technician's request, the manufacturer can provide
additional copies of the machine's Instruction Manual.
1.3 Method for updating the Instruction
Manual
The Manufacturer reserves the right to modify and make im-
provements to the machine without providing notice or up-
dating the Manual that has already been received.
Should the Manual become illegible or other-
wise hard to read, the Technicians must request
a new copy from the Manufacturer before car-
rying out any operations on the machine.
It is absolutely forbidden to remove or rewrite parts of
the Manual.
The instructions, drawings and documentation contained
in this manual are confidential and the sole property of
the Manufacturer. They may not be reproduced in any
way, either in full, or in part without prior authorisation.
The Technician is responsible for complying with the in-
structions contained in this Manual.
Should any incident occur as a result of these recom-
mendations being used incorrectly, the Manufacturer
declines any liability.
This manual is also available on the manufacturer's web-
site via a restricted-access page.
1.4 Recipients
This Manual is intended for the Technician who is responsible
for carrying out the following operations on the machine:
• Transport and handling;
• Storage;
• Installation;
• Commissioning;
• Maintenance;
• Cleaning;
• Spare part replacement;
• Emergency operations and faults;
• Decommissioning;
• Disassembly;
• Disposal (refer to the retailer if not directly responsible).
9
108
of
- Quick Links:
- Machine Diagram
Hide quick links:
Advertisement
Table of Contents
