Rejecting Anonymous Calls; Quicklookup (Number Guessing/Auto Completion) - Snom D717 User Manual

D717 User Manual
R
ejecting anonymous calls
With this setting you will not receive calls from phones whose number is not shown on your display.
Anonymous callers will hear the busy signal.
Please note that calls from analog phone connections will, most likely, be received as
anonymous calls. The default is off.
Setting on the phone
1. Press and select Call Features > Incoming Calls > Reject anonymous .
1. Press to change the setting from no to yes.
2. Press briefly to return to the Call Features menu, press
screen.
Setting on the web interface
1. Open the Preferences page > General tab > Privacy Settings section > Reject incoming
anonymous calls.
2. Select the radio button "Reject" or "Accept".
3. Click on Apply and Save.
Q
uickLookup (number guessing/auto completion)
When QuickLookup is enabled, the phone begins searching its directory and call lists, for names
and numbers containing the sequence typed on the phone's keypad as soon as you have typed the
minimum number of digits specified for this feature. If LDAP is configured on the phone, the phone
will also send an LDAP query. In firmware version 10.1.33.33 and higher the function is enabled in
the default setting, in lower versions it is disabled by default.
The default minimum number of characters that must be entered before number guessing will start
is three (3). There is a short delay before the QuickLookup search begins, so as to avoid unnecessary
searches if the user keeps entering numbers. The search is triggered 500 ms after the last digit was
entered if the required number of digits have been entered.
Using QuickLookup: see "QuickLookup (number guessing/auto completion)" on page 54.
Setting on the phone
1. Press and select Preferences > General.
2. When QuickLookup is enabled (on), the setting for the minimum number of characters is available
in the menu. Select QuickLookup Start Length and press
Note: To disable the feature, select QuickLookup and press
On to Off. When QuickLookup is disabled, select QuickLookup and press
3. Press briefly to return to the Call Features menu, press
screen.
Customizing the Phone Settings
for two seconds to return to the idle
.
to change the setting from
for two seconds to return to the idle
100
to enable it.