Commissioning; General Rules For Handling The Spray Gun - WAGNER GA 4000ACIC-R Translation Of The Original Operating Manual

VERSION 06/2013
OPERATING MANUAL
6.3

COMMISSIONING

6.3.1

GENERAL RULES FOR HANDLING THE SPRAY GUN

Observe safety instructions in Chapter 4.
The following rules must be observed before all work on the device, in the event of work
interruptions and functional faults:
Unintentional putting into operation!
Risk of injury.
Before any work on the device, in the event of work interruptions
and malfunctions:
Cleaning agent in air duct!
Functional faults.
When cleaning, always operate the spray gun at at least 0.05 MPa; 0.5 bar; 7.25 psi
shaping air. No cleaning agent should be allowed to enter the air ducts.
ORDER NUMBER DOC 2312956
WARNING
Switch off the energy/compressed air supply.
Relieve the pressure from the spray gun and device.
Secure the spray gun against actuation.
In the event of functional faults: remedy the fault as described in
the "Troubleshooting" chapter.
NOTICE
32