Touching Hot Surfaces; Use In Areas Subject To Explosion Hazards; Safety Regulations - WAGNER GA 4000ACIC-R Translation Of The Original Operating Manual

VERSION 06/2013
OPERATING MANUAL
4.2.6

TOUCHING HOT SURFACES

Only touch hot surfaces if you are wearing protective gloves.
When operating the device with a coating product with a temperature of > 43 °C;
109.4 °F:
- Identify the device with a warning label "Warning - hot surface".
Order No.
9998910 Instruction label
9998911 Protection sticker
Note: Order the two stickers together.
4.3

USE IN AREAS SUBJECT TO EXPLOSION HAZARDS

The device may be used in areas subject to explosion hazards. The following safety
regulations must be observed and followed.
4.3.1

SAFETY REGULATIONS

Safe handling of WAGNER spray devices
Mechanical sparks can form if the device comes into contact with metal.
In an explosive atmosphere:
Do not knock or push the unit against steel or rusty iron.
Do not drop the device.
Use suitable tools only.
Ignition temperature of the pumped product
Check that the ignition temperature of the pumped product is higher than the max.
allowable surface temperature.
Medium supporting atomizing
To atomize the product, use only weakly oxidizing gases, e.g. air.
Cleaning
If there are deposits on the surfaces, the device may form electrostatic charges. Flames or
sparks can form during discharge.
Remove deposits from the surfaces to maintain conductivity.
ORDER NUMBER DOC 2312956
15