VERSION 06/2013
OPERATING MANUAL
5.4.2
MODES "NC" AND "C"
5.4.2.1
MODE "NC" WITHOUT PRODUCT CIRCULATION
In this mode of operation, the left or the right product
channel in the gun head (A) is locked by the lock pin
(M) and the product entrance (ME) is always on the
opposite side.
5.4.2.2
MODE "C" WITH PRODUCT CIRCULATION
In this mode of operation, the lock pin (M) must be
removed from the left or right product channel in the
gun head (A). Screw on additional connection nipple (J).
The product entrance (ME) and the product return (MR)
are freely selectable in this mode of operation.
5.4.3
FUNCTIONS OF THE SPRAY GUN
Diagram:
Shaping air
Atomizing air
Control air
Product
Circulation
Open:
The piston in the drive is charged with control air and moves toward the rear. This ensures
that the air valve which releases the shaping and atomizing air is opened fi rst. The product
valve is then opened with a mechanical delay. In this position, the pressurized coating
product is applied to the work piece.
ORDER NUMBER DOC 2312956
A
M
B_03069
A
M
J
B_03489
Nozzle
4x 4 Nm; 2.95 lbft
B
ME
D
4x 4 Nm; 2.95 lbft
B
MR
ME
D
25