Simple Network Management Protocol (Snmp) - Weidmuller UR67 Series Manual

"Input delay" parameter
This parameter defines the filter behaviour of an input.
No
Signals are not filtered.
0.3 ms ... 20 ms (default: 3 ms)
Signals lasting less than 0.3 ms ... 20 ms are filtered.
"Substitute value" parameter
This parameter is used to set the behaviour of the associated
output in the event of disrupted fieldbus communication.
Off (default)
The output is inactive in the event of disrupted fieldbus com-
munication.
On
The output is active in the event of disrupted fieldbus com-
munication.
Hold last value
The output is held at the last value in the event of disrupted
fieldbus communication.
"Channel diagnosis" parameter
This parameter activates channel diagnostics for the associ-
ated channel.
Disabled (default)
Channel diagnostics are disabled for this channel.
Enabled
Channel diagnostics are enabled for this channel.
"Channel diagnosis DO" parameter
This parameter activates channel diagnostics for the associ-
ated output.
Disabled (default)
Channel diagnostics are disabled for this channel.
Enabled
Channel diagnostics are enabled for this channel.
"Channel diagnosis DI" parameter
This parameter activates channel diagnostics for the associ-
ated input.
Disabled (default)
Channel diagnostics are disabled for this channel.
Enabled
Channel diagnostics are enabled for this channel.
2599890000/01/03.2020
6 Commissioning | Simple Network Management Protocol (SNMP)
6.5 Simple Network Management Protocol
(SNMP)
The UR67-PN-V14 modules support the objects listed in the
PROFINET specification in accordance with the SNMP v1
protocol standard. This includes objects from RFC 1213 MIB-
II (system group and interfaces group) and from LLDP-MIB.
The community strings are:
– Read Community: public
– Write Community: private
Manual UR67-PROFINET-V14 27