Soft-Reset Of Infinea X; Enable/Disable Sync Mode; Update Software - Infinite Peripherals Infinea X User Manual
For iphone 6s/7/8/se
Hide thumbs
Also See for Infinea X:
- User manual (34 pages) ,
- Quick start manual (2 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
Infinea X User Manual
Soft–Reset of Infinea X
You can reboot the Infinea X without removing your iOS device. This
functionality cycles the unit's power and restarts your Infinea X.
1.
Press the Scan and Battery Status buttons together for three seconds.
2.
Once you hear a beep as confirmation the main computer board is reset,
release both buttons to restart the Infinea X.
Note:
Repeat the above steps if the unit does not restart.
Enable/Disable Sync Mode
To sync your iOS device with iTunes with the Infinea X, connect the
Infinea X to a personal computer or MAC using the charging cup.
1.
Once in sync mode, refer to the iTunes documentation for the procedure
to sync your iOS device.
2.
If syncing does not occur, contact your account executive or
developer.ipcmobile.com
enabled within your application.
3.
To disable sync mode, exit iTunes, and then unplug the unit
from the charging cup.
Update Software
1.
To update the software with a newer version from the application, tap
Update Firmware.
2.
Tap Update.
3.
To update the barcode engine with a newer version, tap Update
Barcode Engine Firmware. The current firmware version and the new
firmware version are displayed.
4.
Tap Update.
https://
as this functionality may not be
12
Advertisement
Table of Contents
Need help?
Do you have a question about the Infinea X and is the answer not in the manual?
Questions and answers