Raven SmarTrax Installation Manual page 16

Chapter 3
Install the two large, rectangular connectors of the node harness (P/N 115-4001-127) into the correct ports
2.
of the node.
Tighten the bolts on the harness connectors to secure the connections.
3.
Place the node mounting bracket in the instructional seat compartment, aligning the holes in the mounting
4.
bracket with the existing mounting studs.
Note:
The node connectors should be pointing toward the operator's seat.
Secure the node mounting bracket to the floor using four 1/4" flat washers (P/N 313-2300-009) and four M6
5.
lock nuts (P/N 312-4000-207).
Node Harness Routing Location
FIGURE 7.
Node Harness
Routing Location
Route the remaining node harness through the instructional seat access hole and around the back of the
6.
operator's seat.
CAN Connector Installed on Machine's DIAGNOSTIC Connector
FIGURE 8.
Connect the CAN extension cable (P/N 115-4001-150) to the machine's existing DIAGNOSTIC connector
7.
bolted to the fuse panel as shown in Figure 8.
12 Case IH Patriot 4420 - Steering Ready (2009 & Newer) SmarTrax™ Installation Manual