Raven SmarTrax Installation Manual page 44

C 5
HAPTER
FIGURE 11. Valve Harness Connected to Tee Safety Harness
3. Connect the male 12-pin connector of the tee safety harness to the CHASSIS connector of the valve harness
(P/N 115-4001-237).
4. Route the valve harness out through the grommet in the right-rear window to the underside of the tractor.
5. Replace the exterior back panel of the machine.
6. Route the valve harness under the cab and toward the right side of the machine.
NOTE: The harness should follow along the right side of the tractor. Do not route near moving parts, heat
sources, or sharp edges.
FIGURE 12. Valve Harness Connected to SmarTrax Valve
7. Plug the TRANSDUCER connector of the valve harness into the pressure transducer installed in Port PS of the
SmarTrax valve.
8. Connect the 4-pin connector on the valve harness into the open 4-pin connection port on the SmarTrax valve.
40
Case IH MX 180-270, MFWD Axles - Model Year 1999-2002 SmarTrax™ Installation Manual