Raven SmarTrax Installation Manual page 37

Case ih mx 180-270, mfwd axles - model year 1999-2002

Hide thumbs Also See for SmarTrax:

Table of Contents

FIGURE 5. Rod Mounting Bracket Installed

7. Insert the 3/8"-16 x 1.25" bolt (P/N 311-0054-106) through the center of the WAS mounting bracket (P/N 107-

0172-030).

8. Install the WAS rod mounting bracket on the ends of the muffler clamp and secure it using two 5/16" nylon

insert lock nuts (P/N 312-4000-059) as shown in Figure 5.

FIGURE 6. Base-End of Sensor Installed on Machine

9. Install the base-end of the WAS on the base mounting bracket using the supplied 3/8"-16 x 1.75" bolt (P/N 311-

0054-108), spacer (P/N 107-0172-103), and 3/8"-16 lock nut (P/N 312-4001-109).

P/N 016-5032-033 Rev. A

WHEEL ANGLE SENSOR INSTALLATION

Table of Contents