Raven SmarTrax Installation Manual page 38

C 4
HAPTER
FIGURE 7. Rod-End of Sensor Installed on Machine.
10. Mount the rod-end of the WAS to the rod mounting bracket using a 3/8"-16 nylon insert lock nut (P/N 312-
4001-109).
11. Adjust the muffler clamp so that when the wheels are turned to the right lock, there is approximately 1" of
stroke left on the WAS.
FIGURE 8. Muffler Clamp Adjusted
WAS Cable
Connection
12. Ensure the WAS connector is easily accessible for cable installation.
13. Tighten all WAS installation hardware.
IMPORTANT: Verify that the WAS cannot be overextended or compressed when the wheels are turned to their extremes
and adjust the wheel stops as necessary. Also verify that the sensor moves freely and is not being
damaged within its range of motion.
34
Case IH MX 180-270, MFWD Axles - Model Year 1999-2002 SmarTrax™ Installation Manual