Raven SmarTrax Supplement Installation Manual page 9

Installing the
Steering
Control Valve
Hoses
Left Steer Hose
1. Identify the left steer port on the tractor steering orbital. Hoses may
need to be traced to the hydraulic cylinders for proper identification.
Once the port has been identified, remove the hose from the steering
orbital and install on the appropriate tee fitting, found in the Raven
adapter kit, to the steering orbital. Once the tee fitting is installed, re-
attach the original hose.
2. Attach hose (P/N 214-1000-204) to the A-Port on the Raven steering
control valve, route to and attach to the open branch on the installed tee
fitting using a 90° fitting.
3. An additional 45° or 90° elbow may be installed on the Raven valve to
help hose routing. These elbows will be found in the hydraulic fitting kit.
Right Steer Hose
1. Identify the right steer port on the tractor steering orbital. Hoses may
need to be traced to the hydraulic cylinders for proper identification.
Once the port has been identified, remove the hose from the steering
orbital and install an appropriate tee fitting, found in the Raven adapter
kit, to the steering orbital. Once the tee fitting is installed, reattach the
original hose.
2. Attach hose (P/N 214-1000-205) to the B-Port on the Raven steering
control valve, route to and attach to the open branch on the installed tee
fitting using a 90° fitting.
3. An additional 45° or 90° elbow may be installed on the Raven valve to
help hose routing. These elbows will be found in the hydraulic fitting kit.
Manual # 016-0190-026
C
H A P T E R
H
YDRAULICS
7