Raven SmarTrax Supplement Installation Manual page 11

LS-PV Hose
1. Remove fitting from the LS-PV port on the SmarTrax valve. Insert the
supplied SAE O-Ring to o-ring face seal adapter fitting.
2. Remove the load sense hose from the steering orbital and connect the
hose directly to the port labeled "LS-PV" on the Raven steering control
valve. To identify the load sense port on the valve, a general rule of
thumb is that the smallest hose on the orbital is the load sense hose.
Once the hose is identified, follow the hose to its origin and verify that
the hose is running from the tractor's priority valve.
Tank Hose
1. Identify the tank port on the tractor steering orbital. Hose may need to
be traced to the hydraulic reservoir for proper identification. Once the
port has been identified, remove the hose from the steering orbital and
install an appropriate tee fitting, found in the Raven adapter kit, to the
steering orbital. Once the tee fitting is installed, reattach the original
hose.
2. Attach hose (P/N 214-1000-203) to the T-Port on the Raven steering
control valve, route to and attach to the open branch on the installed tee
fittings using a 90° fitting.
3. It is extremely important that the tank line running to the Raven steering
control valve goes to the port designated "T". Failure to do so will result
in internal o-ring failure on the valve.
4. An additional 45° or 90° elbow may be installed on the Raven valve to
help hose routing. These elbows will be found in the hydraulic fitting kit.
LS-Steer Hose
1. Run hose (P/N 214-1000-207) from the open branch on the tee to the
load sense port on the tractor's steering orbital. This port should be open
since the original hose was removed and run to the LS-PV port in the
previous step.
Connect the Pressure Switch directly to the PS port on the SmarTrax valve.
Manual # 016-0190-026
9