Raven SmarTrax Installation Manual page 24

Chapter 5
To Install the Node:
Select the preferred location for the node. See the recommendations for choosing a mounting location
1.
above.
Note:
For 07' and newer machines, the suggested location is located in the lower right hand panel. An
additional kit 117-0171-300 is available. Spacers to stack the nodes are provided in the kit when
AccuBoom node is also installed.
Node Mounting Location
FIGURE 3.
Connect the rectangular 12 pin connector on the node cable (P/N 115-4001-011) for Viper Pro/Envizio Pro
5.
or (P/N 115-4001-013) for Cruizer to the SmarTrax valve cable harness (P/N 115-4001-002).
Connect the large, rectangular connector to the SmarTrax node.
6.
Connect your receiver or source of DGPS to the connector labeled 'DGPS' on the node adapter cable.
7.
Connect the console providing machine guidance to the remaining DB-9 connector.
8.
Connect the 4-pin deutsch plug to the vehicle's CANbus system (Viper Pro/Envizio Pro) or the DB-9 display
9.
cable (Cruizer).
Electrical hookup is recommended as shown in the Can Node Wiring Diagram on page 26.
10.
Note:
High Current Power, which is used to run steering operations, should be connected to a separate
power source than Logic Power, which is used to run processing and communication between the
node and the guidance console.
20 Ag-Chem RoGator 84/86C Series SmarTrax Installation Manual