Raven SmarTrax Installation Manual page 29

When using the supplied hydraulic node cable (P/N 115-4001-072), connect the round AMP Power to the
12.
plug in the left or right rear of cab as shown in the figure below. The left side is preferred as the seat may
interfere with the right side.
Hydraulic Valve Node Cable
FIGURE 8.
Note:
High Current Power, which is used to run steering operations, should be connected to a separate
power source than Logic Power, which is used to run processing and communication between the
node and the guidance console.
Manual No. 016-4001-023
Wiring and Electrical Connections
25