Raven SmarTrax Installation Manual page 31

Node Harness Installed on Node
FIGURE 16.
Install the two large, rectangular connectors of the node harness (P/N 115-4001-196) into the correct ports
1.
of the node, tightening the bolts on the harness connectors to secure the connections.
Locate the ENABLE connector on the node harness and connect it to the foot switch cable connector.
2.
Node Harness Routing
FIGURE 17.
Route the node harness into the blower fan compartment located in the right-rear corner of the cab.
3.
Manual No. 016-4001-126 Rev. B
Cab Component Installation
27