Node Mounting Locations - Raven SmarTrax Installation Manual

Chapter 5
Cover Plate to be Removed
FIGURE 7.
Remove the cover plate from the bulkhead as shown in the figure above.
9.
Install the supplied bulkhead cover plate (P/N 107-0172-193) on the bulkhead cover panel using the nuts
10.
and bolts removed in step 9.
From inside the cab, install the round bulkhead connector through the hole in the bulkhead cover panel.
11.
Tighten the bulkhead nut to secure the connection.
12.

Node Mounting Locations

Node Mounting
FIGURE 8.
When choosing the location for the SmarTrax node, consider the following points:
•
Mount the SmarTrax node inside the machine's cab on a flat, level surface for proper performance and
cable connection.
•
One of the six numbered direction arrows on the node must be oriented in the direction of forward vehicle
travel, one arrow pointing straight up, and two of the arrows parallel to the ground.
Note:
Make a note of the number of the arrow that is oriented in the direction of forward vehicle travel.
This number will be needed during the SmarTrax calibration process.
•
The node mounting location must not create tripping hazards.
•
Mount the node in a location where it will not be kicked or jarred during normal equipment operation.
24
Miller Condor GC Series & New Holland Guardian R Series SmarTrax™ Installation Manual
Direction Arrows
Any two arrows must
be parallel with level
ground
4
5
Mounting Tabs
1
2
3