Chapter 5
SmarTrax Node Installed
FIGURE 2.
Install the two large, rectangular connectors of the node harness (P/N 115-4001-139) into the correct ports
3.
of the node, tightening the bolts on the harness connectors to secure the connections.
Mount the SmarTrax node (P/N 063-0173-228) to the node mounting plate using three 3/8"-16 x 1-1/4" bolts
4.
(P/N 311-0054-106).
Note:
The node forward direction number as shown in the figure above is 6.
19-Pin Deutsch Connection
FIGURE 3.
Connect the round 19-pin Deutsch connection on the node harness to the mating connector on the
5.
machine's harness, located in the node compartment.
22
Miller Condor GC Series & New Holland Guardian R Series SmarTrax™ Installation Manual