Power Fail - Honeywell NOTIFIER ID61 Operating Manual

If both the AC and
Battery power fail, the
indicators and LCD are
non-operational.
DISABLEMENT
TEST POWER SUPPLY FAULT
DELAYS ACTIVE
FIRE OUTPUT: FAULT / DISABLED
FIRE OUTPUT ACTIVE
SOUNDER: FAULT / DISABLED
PLANT ALARM
POWER
FIRE CONTROL O/P: FAULT / DISABLED
997-458-000-8, Issue 8
January 2010
ID61/62 Series Panel - Operating Manual
2 If a service contact number has been entered during
A
FAULT
E
For Service Contact ***** ******
Note: Press the MUTE BUZZER pushbutton to silence
3 When the cause of the fault has been cleared, press
Status: NORMAL
Sat 05/01/2002

3.3.1 Power Fail

The loss of a power supply causes the panel to enter a
Power Fail condition. This condition is confirmed by the
illumination of the POWER SUPPLY FAULT LED, general
FAULT LED and the operation of the internal buzzer. The
LCD displays:
a. Fault indication
b. Fault number currently displayed
c. Total number of faults logged
d. Time fault was logged
FAULT
e. A text message describing the fault.
EARTH FAULT
SYSTEM FAULT
A
PRE- ALARM
E
A battery fault is shown on the LCD as follows:
FAULT
BATTERIES MISSING
2 If a service contact number has been configured, the
Note: Press the MUTE BUZZER pushbutton to silence
3 When the cause of the fault has been cleared, press
Status: NORMAL
Sat 05/01/2002
10
panel commissioning, the LCD alternates between
the fault message(s) and the following:
B C
01 / 03
the panel's internal buzzer.
the RESET pushbutton.
B C
FAULT 01 / 02
NO MAINS SUPPLY
01 / 02
LCD alternates between the power fault message and
the service contact number.
the panel's internal buzzer.
the RESET pushbutton.
D
14:55
00:00:00
D
14:55
14:55
00:00:00