Faults - User Option - Honeywell NOTIFIER ID61 Operating Manual

3
A B C D E
FAULT 01 / 03 Z01
NO REPLY FROM DEVICE
FAULT
NO REPLY FROM DEVICE
2
997-458-000-8, Issue 8
January 2010
ID61/62 Series Panel - Operating Manual
AWACS
The ID61/62 panels allow the configuration of all sensor
types, except HEAT sensors, to use the AWACS
sensing algorithm. For these devices an additional screen
is available which displays the current percentage values
for alarm and pre-alarm.

4.12.3 Faults - User Option

This menu option allows the user to view active faults
while the normal active fault display has been overridden
by a higher priority display (alarms). To view Faults, from
the View Mode menu:
1 On the numeric keypad, press the '
the Faults display.
[U0 View] 1:Log
4:Input Events
2 The LCD automatically displays the last recorded
event first. Viewing commences from this point. Press
the '
Note: Press the '
F G H
M12 MCP 14:55
03/ 03 Z01 S23 TMP
6
FAULT
< - - - Zone Text - - - >
Note: If no faults are recorded on the system, the
The system has NO faults present
3 Press the '
menu.
40
Devices
TM
2:Devices 3:Faults
5:Disabled
/ ' buttons to scroll through the faults.
2 8
' button to view additional zone text
6
information. To return to the fault message press
any numeric/cursor key. Alternatively, if no key is
pressed within ten (10) seconds the display reverts
to the fault message. Example fault displays are
given below:
a. Fault condition
b. Fault currently displayed.
c. Total number of faults
logged.
8
>
d. Text description of fault.
e. Zone Number.
14:55
f. Device Address.
>
g. Device Type.
h. Time fault was logged.
01 / 03 Z01 M12 MCP
< - - - Device Text - - - >
following message is displayed:
' button to return to the View Mode
4
multi-
TM
' button to select
3
: More
14:55
<:Exit