Honeywell NOTIFIER ID61 Operating Manual page 13

ZONE FIRE
1 2 3 4
ZONE FAULT
DISABLE/TEST
FIRE
DISABLEMENT
TEST POWER SUPPLY FAULT
SOUNDER: FAULT/DISABLED
FIRE CONTROL O/P: FAULT/DISABLED
A B C D
FAULT 01 / 03 Z01
NO REPLY FROM DEVICE
ID61/62 Series Panel - Operating Manual
3.3 Fault
Automatic panel actions:
If a fault occurs, the panel automatically does the
following:
a. Operates the internal buzzer (2 sec. on, 1 sec. off).
FAULT
b. Flashes the appropriate FAULT LEDs, including
EARTH FAULT
SYSTEM FAULT
c. Operates any control outputs which are associated
PRE-ALARM
Recommended operator actions:
1 A fault message typically displays information as
Depending upon the fault message, either:
i
E F G H
M12 MCP 14:55
FAULT
6
< - - - Zone Text - - - > < - - - - Device Text - - - - - >
Note: Press the '
ii If the fault message relates to a system fault condition,
Note: e, f, and g are not applicable.
A
D
numbered ZONE FAULT/ DISABLE/ TEST LED(s) if
appropriate.
in the Control-by-Event Rules with fault events.
follows (not all items apply to all types of fault):
a. Fault indication,
b. Fault currently displayed,
c. Total number of faults logged,
d. A text message identifying the nature of the fault,
e. Zone Number,
f. Device Address,
g. Device Type
h. Time fault was logged.
If the fault message relates to a specific loop device,
investigate whether the cause of the fault is
immediately apparent and can be corrected.
>
01 / 03 Z01 : M12 MCP
' button to view additional zone text
6
information. To return to the fault message press
any numeric/cursor key. Alternatively, if no key
is pressed within ten (10) seconds the display
reverts to the fault message.
as displayed below, note the full description of the
fault and notify the authorised servicing company:
B C
FAULT 01 / 03
EARTH FAULT
9
14:55
H
14:55
997-458-000-8, Issue 8
January 2010