Plant Alarm; Fault Output: Fault/Disabled (Optional) - Honeywell NOTIFIER ID61 Operating Manual

ID61/62 Series Panel - Operating Manual
FIRE OUTPUT ACTIVE

PLANT ALARM

POWER
Status: NORMAL
Sat 01/12/2001
FIRE OUTPUT: FAULT / DISABLED
FIRE OUTPUT ACTIVE
FAULT OUTPUT: FAULT/DISABLED
3.4 Plant Alarm
A Plant Alarm indication is the default configuration
setting for ID61/62 Series fire control panels. In this
configuration, the panel operates as follows:
A Plant Alarm message is displayed if the panel detects
a non-fire input (AUX) configured in zones 17 to 32. When
a non-fire event occurs the Plant Alarm LED is illuminated
(except for Hold Switch and Abort Switch AUX inputs)
and the LCD displays the following information:
a. Plant Alarm condition.
b. Alarm number currently displayed.
c. Number of alarms.
d. Zone number.
e. Device address.
f. Device type.
g. Time of logged message.
h. Zonal and device text (if any).
A B C
PLANT 01 / 01
< - - - Zone Text - - - > < - - - Device Text - - - >
H
When the cause of the alarm has been cleared the
message will automatically be removed from the LCD
and the LED extinguished. The panel returns to quiescent
mode.
00:00:00
3.5 Fault Output: Fault /Disabled (Optional)
If the panel has been configured to indicate the status of
the Fault Output relay circuit, a message is displayed if
a Fault Output relay circuit fault condition is detected or
if it has been disabled.
Note: An output device configured to a Fault CBE rule
remains active if disabled from a source other than
the panel Fault Output relay disable function.
11
D E F
Z21 M12 AUX 14:55
G
FIRE OUTPUT ACTIVE
PLANT ALARM
POWER
997-458-000-8, Issue 8
January 2010