Zones - User Option - Honeywell NOTIFIER ID61 Operating Manual

3
ZONE FIRE
ZONE FAULT
DISABLE/TEST
or
2 8
OPAL Protocol Devices in Walk Test
When a zone with OPAL protocol enabled
is put into Walk Test, the OPAL device
LEDs flash green with a longer* ON
duration to indicate that the device is
ready for testing.
When a device is tested the green LED will
show red momentarily, with an end to the
green prolonged flash to indicate that
testing is now finished for that device.
* Approximately 1 sec. ON/1 sec OFF.
997-458-000-8, Issue 8
January 2010
ID61/62 Series Panel - Operating Manual

4.9.3 Zones - User Option

The Test Zones option, selected from the Test Menu, allows
the user to perform a walk test on one zone at a time.
During the walk test the TEST and relevant FAULT/
DISABLE/TEST LEDs are illuminated, indicating that the
system and zone is in TEST mode. To perform a walk
test, at the TEST menu:
1 Press the '
[U0 Test]
4:Auto High Test 5:Outputs
2 The LCD displays the Test Zones menu. Select either
[U0 Zones]
2:No Sounders
a. Using the numeric keypad, press '
1 2 3 4
FIRE
[WALK TEST (Sounders)]
: Start
DISABLEMENT
TEST
DELAYS ACTIVE
i
5
[WALK TEST (Sounders)] Select Zone: 01
Press
ii The LCD prompts for confirmation. Press the '
[WALK TEST (Sounders)] Select Zone: 01
: Start
iii Press the '
b. To walk test devices on a specific zone without activating
3 To end the walk test:
a. For a specified zone: at the Test Zones menu, press
[STOP WALK TEST] Select Zone: 01
: Stop
22
' button on the numeric keypad to select
3
the walk test procedure.
1:LEDs 2:LCD
the Ring Sounders or No Sounders walk test:
1:Ring Sounders
3:View/Stop Test
Ring Sounders menu as shown below. In this mode
the sounders will ring for a few seconds when a device
is tested, then reset automatically.
Select Zone: 01
: Change
Use the ' / ' buttons to select the zone to be
2 8
tested. Press the ' ' button to confirm the zone
5
number.
to Confirm
button to start the walk test for this zone. Repeat
steps i and ii for any further zones to be tested. Test
the devices (see Checking the Devices overleaf).
: Change
' button to exit the Ring Sounders menu
4
and return to the Zones menu.
the sounder, press ' ' on the numeric keypad to select
2
the 'No Sounders' option. The walk test procedure is
otherwise the same as given above for 'Ring Sounders'.
the ' ' button on the numeric keypad to select the
3
View/Stop Test menu:
: Change
3:Zones
: More
: More
' to display the
1
<:Exit
<:Cancel
'
5
<:Exit
<:Exit