JRC JUE-87 Instruction Manual page 36

Step 8 Display of the lowest line of window is changed to [F1: SSAS TEST ON] again, when the Security
Alert transmission test is completed.
Fig.3.4.1i Security Alert Transmission Window (Test Transmission is Completed)
1. The MES starts transmission with setup of "Security Alert transmission #1" immediately after pressing
function key 1 <F1>. If the another setup has been configured, the MES starts transmission with setup of
"Security Alert transmission #2" at 12 minutes after pressing function key 1 <F1>, starts transmission with
setup of "Security Alert transmission #3" at 24 minutes after pressing function key 1 <F1>, starts
transmission with setup of "Security Alert transmission #4" at 36 minutes after pressing function key 1
<F1>, and starts transmission with setup of "Security Alert transmission #5" at 48 minutes after pressing
function key 1 <F1>.
2. This test mode remains after one hour from pressing function key 1<F1>.
3. Your creating message and the following message are transmitted to pre-designed destinations.
TEST TEST
MES NO, 123456789
LAT,N12 34.56LON,E123 45.56,UTC,07.01.2004 12:34,SOG, 10.0KT,COG,20DEG
4. The Security Alert transmission test mode is cancelable if the power switch on the IME to OFF and ON
within one hour from pressing function key 1<F1>.
5. Different to real transmission, the message of [arrival confirmation] is displayed on sender's DTE at test
mode.
Set up
Date & time
confiG
Security Alert transmission
log-Out initiation
log-In initiation Security Alert transmission#1
Performance test initiation
Security Alert transmission#2
Scheduled transmission
Security Alert transmission#3
Land id registration for polling
Security Alert transmission#4
Closed network id selection Security Alert transmission#5
Peripheral Function
F1: SSAS TEST ON
passWord
EPADR informAtion
F10:Previous
NOTE
3-22
F10:Previous