JRC JUE-87 Instruction Manual page 35

Step7 Select [OK] by cursor and press <Enter> key, then the warning window is cleared, then Security Alert
transmission test is started.
The Security transmission #1 to #5 is automatically sent once, if each [Setting of Security Alert] is
set to [oN].
Display of the lowest line of window is changed to [F1: SSAS TEST OFF] from [F1: SSAS TEST
ON], while executing the test.
Fig.3.4.1g Security Alert Transmission Window (After the Test Transmission is Started)
* When you cancel the test, press function key1<F1>. And select [OK] by cursor and press
<Enter>key when following warning window is displayed. The test stops.
Fig.3.4.1h Warning Window (Confirming Stop of the Test)
* When you continue the test, select [Cancel] and press <Enter>key. Then the test is continued.
Set up
Date & time
Security Alert transmission
confiG
log-Out initiation
Security Alert transmission#1
log-In initiation
Security Alert transmission#2
Performance test initiation
Security Alert transmission#3
Scheduled transmission
Security Alert transmission#4
Land id registration for polling
Security Alert transmission#5
Closed network id selection
Peripheral Function
F1: SSAS TEST OFF
passWord
EPADR informAtion
F10:Previous
Set up
Date & time
Security Alert transmission
confiG
log-Out initiation
Security Alert transmission#1
log-In initiation
Performance test initiation Security Alert transmission#2
Scheduled transmission Security Alert transmission#3
Warning
Security Alert transmission#4
Land id registration for polling
Security Alert transmission#5
Closed network id selection
Start SSAS Test?
Peripheral Function
OK Cancel
F1: SSAS TEST ON
F10:Previous
3-21
F10:Previous
F10:Previous
3