Revision History - Broadcom Brocade DCX 8510-4 Backbone Hardware Installation Manual

53-1002177-19 Hardware Installation Guide

Revision History

53-1002177-19; 2 June 2020
The following changes have been made:
•
Removed the "Brocade DCX 8510 Technical Specifications" section from this guide. The technical specifications are
provided in a separate guide.
•
Modified the following sections in
–
Removed the "Verifying the PID mode" section from the "Initial setup and configuration" section as it is no longer
necessary for configuration.
–
Recording critical device information
note to run the
supportShow
and added more information to the step to enter the
–
Reconnecting the system to the network and fabric
configuration" for connecting a serial cable, establishing a serial connection, configuring IP addresses, and
establishing an Ethernet connection to the device.
–
Verifying correct operation of system
fabric.
–
Verifying correct configuration of the fabric
the WWN of the new chassis.
•
Corrected the torque requirements in the following sections of "Installing the 8U Chassis Airflow Diversion or Port Side
Exhaust Kit for Four-Post Racks (XBR-DCX4S-0121 and XBR-DCX4S-0130)":
–
"Installing device in 18-24 inch rack (XBR0DCX4S-0130)"
–
"Installing device in 27-31 inch rack (XBR-DCX4S-0121)"
Broadcom
Chassis removal and replacement:
– Revised the introduction to using critical information checklist, removed the
command, removed the -sw option from the step to enter the
supportShow
– Revised Step 1 to include references to sections in "Initial
– Moved this section to after
– Added a step to modify the SCC policy for a fabric, if one exists, to add
Brocade DCX 8510-4 Backbone Hardware Installation Guide
command.
Reconnecting the system to the network and
command,
ipAddrShow
53-1002177-19
173