Printer Property - JRC JHS-770S Instruction Manual

5.6.2

Printer property

When connecting the printers, configure the conditions as appropriate according to the printer type, as follows.
■ ■
Procedure
1 1 . .
1 .
Press the key, and through hierarchical
MENU
menus, select the 9.7 Printer property.
2 2 . .
2 .
Select the printer and press ENT.
If selecting 1. Controller printer, the screen is displayed as
shown at right.
3 3 . .
3 .
Set the desired items conditions as appropriate.
Note
The content and the concerned information of each item are as follows.
Printer type Selective item
Connection
Data out
Controller
Baudrate
printer
Flow control
Print direction
Connection
Transceiver
Data out
printer
Print direction
Selective conditions
Content
( : Factory default)
Connection status and
None/ Serial
the printer type
Printing method for the
Auto/ Manual
DSC message
Transmission speed to
4.8k/ 9.6k/ 38.4kbps
the printer
Handshake setting with
Hard/ None
the printer
Printing sequence of
Invert/ Upright
the lines
Connection status and None/NKG-52/
the printer type Centronics
Printing method for the
Auto/
DSC message
Printing sequence of
Invert/ Upright
the lines
(NKG-52: "Invert" only)
9.7)Printer property
1.Controller printer
2.Transceiver printer
0.Back
9.7.1)Controller printer
1.Connection
2.Data out
3.Baudrate
4.Flow control
5.Print direction:Invert
0.Back
9.7.1)Controller printer
1.Connection
2.Data out
3.Baudrate
4.Flow control
5.Print direction:Invert
0.Back
Settings for each printer
NKG-91
Serial
Auto
4.8k
Hard
Invert
---
Manual ---
---
Settings & Registrations
:None
:Auto
:4.8k
:Hard
:None
:Auto
:4.8k
:Hard
DPU-414 NKG-52
Serial ---
Auto ---
4.8k ---
Hard ---
Upright ---
--- NKG-52
--- Auto
--- Invert
5-17