Receiving With Scanning - JRC JHS-770S Instruction Manual

Operation
4.2.4

Receiving with scanning

Scanning function enables to watch multiple channels (additional channels) with the priority channel
(CH16). If found receiving signal on the additional channels, the dwell time on that channel will be
longer, but continued to watch the CH16 alternatively. The scan mode can be selected from the
following modes.
・ All CH scan Mode:
・ Memory CH scan Mode:
・ Select CH scan Mode:
■ ■
Procedure
1 1 . .
1 .

Press
FUNC 2
The menu is displayed as shown at right.
2 2 . .
2 .
Move the cursor to the desired item and
press ENT using the jog dial, or press the
item number by a numeric key directly.
 If selected "1. All CH scan" or "2. Memory CH
scan", scanning starts immediately.
 If selected "3. Select CH scan", specify the
channel range as described below.
1) To set the start channel (From):
Press ENT and after entering the
channel number, press ENT again.
2) To set the stop channel (To):
Press ENT and after entering the
channel number, press ENT again.
3) To start the scanning:
Select Execute and press ENT. Then
starts the scanning as shown at right.
- Disabled to scan when the channel
Note
region is Inland Waterways (IWW).
- CH70 is skipped, even if contained
in the scanning range.
3 3 . .
3 .
To terminate scanning, press the
 After terminated, the radiotelephone is set on
the last additional channel. (The example at
right shows when stopped on CH12.)

Scanning is also terminated when detected
off-hook, PTT ON, or pressing the
- While scanning, the radiotelephone scans CH16 and the additional channels
Note
alternatively in a cycle of 0.14/0.86 seconds.
- If the squelch is opened on the CH16, paused scanning and continues to watch on
the CH16.
4-8
Scans all channels in the current channel mode.
Scans all memory channels.
Scans the specified range of channels.
.
SCAN
CANCEL
CH16
If squelch is closed again, the scanning will resume 2 seconds later.
7.1)Scan
1.All CH scan
2.Memory CH scan
3.Select CH scan (ITU)
- From : CH
- To
- Execute
0.Back
7.1)Scan
1.All CH scan
2.Memory CH scan
3.Select CH scan (ITU)
- From
- To
- Execute
0.Back
key.
key.
: CH
: CH
: CH