Emerson Mentor MP Advanced User's Manual page 10

Parameter structure Keypad and display
Figure 2-3 Display modes
Status
Mode
(Display
not
flashing)
Parameter
Mode
(Upper
display
flashing)
* can only be used to move between menus if L2 access has been enabled Pr 11.44 (SE14, 0.35)
**Time-out defined by Pr 11.41 (default value = 240s).
Figure 2-4 Mode examples
Parameter
View Mode
Menu 5. Parameter 5
Pr 5.05 value
Do not change parameter values without careful
consideration; incorrect values may cause damage or a
safety hazard.
WARNING
NOTE
When changing the values of parameters, make a note of the new
values in case they need to be entered again.
NOTE
For new parameter-values to apply after the AC supply to the drive is
interrupted, new values must be saved.
10
Parameter description
Parameter x.00
Timeout**
To enter Parameter
Mode, press key or
Use
* keys
to select parameter for editing
To enter Edit Mode,
press key
RO R/W
parameter parameter
Edit Mode
(Character to be edited in lower line of display flashing)
Change parameter values using
Healthy Status
www.controltechniques.com
Advanced parameter
format descriptions
To return to
Status Mode,
press
When returning
to Parameter
Mode use the
*
keys to select
another parameter
to change, if
required
To exit Edit Mode,
press key
Status Mode
Alarm Status
Serial comms
protocol
Timeout** Timeout**
key
Temporary
Parameter
Mode
(Upper display
flashing)
keys.
Trip Status
Drive status = tripped
Trip type (UU = undervolts)
Mentor MP Advanced User Guide
Performance
Issue Number: 1