Emerson Mentor MP Advanced User's Manual page 137

Parameter Keypad and
structure display
Pr 11.38 String Type/mode
0 FrEE Value when Pr 11.37 = 0
1 3C.SE Commander SE mode parameter file (not used)
2 3OpEn.LP Open-loop mode parameter file
3 3CL.VECt Closed-loop vector mode parameter file
4 3SErVO Servo mode parameter file
5 3REGEn Regen mode parameter file
6-8 3Un Unused
9 4C.SE Commander SE mode difference from default file (not used)
10 4OpEn.LP Open-loop mode difference from default file
11 4CL.VECt Closed-loop vector mode difference from default file
12 4SErVO Servo mode difference from default file
13 4REGEn Regen mode difference from default file
14-16 4Un Unused
17 LAddEr Onboard Application Lite user program file
A file containing user defined data (normally created by an SM-
18 Option
Applications option module)
A file containing user defined data (normally created by an SM-
19 OptPrg
Applications option module user program (Digitax ST only)
11.39 SMARTCARD data version
Bit SP
Coding
Range 0 to 9,999
Default 0
Update rate Background read/write
Gives the version number of the data block. This is intended to be used when data blocks are used as drive macros. If a version number is to be
stored with a data block this parameter should be set to the required version number before the data is transferred. Each time Pr 11.37 is changed by
the user the drive puts the version number of the currently viewed data block in this parameter.
11.40 SMARTCARD data checksum
Bit SP
Coding
Range 0 to 65,335
Update rate Background write
Gives the checksum of the data block, space left on the card, the total space on the card for the card flags see Pr 11.37 for details.
11.41 Status mode time-out
Bit SP
Coding
Range 0 to 250 s
Default 240
Update rate Background read
Sets the timeout for the drive display to revert to status mode from edit mode following no key presses. Although this parameter can be set to less
than 2s, the minimum timeout is 2s.
11.42 Parameter cloning
Bit SP
Coding
Range 0 to 4
Default 0
Update rate Background read
* Modes 1 and 2 are not US (i.e. not saved when drive parameters are saved), mode 3 and 4 are US.
Mentor MP Advanced User Guide
Issue Number: 1
Parameter description
Parameter x.00
format
FI DE Txt VM DP ND
FI DE Txt VM DP ND
1
FI DE Txt VM DP ND
FI DE Txt VM DP ND
1
www.controltechniques.com
Advanced parameter
descriptions
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 * 1
Serial comms
Performance
protocol
PS
1
PS
1
PS
1
PS
1
Menu 11
137