Checking Transmission Fluid Level; Checking Engine Oil Level - Kioti DK Series Owner's Manual

6-8 DK651/751/801/901
CHECKING TRANSMISSION FLUID
LEVEL
(1) Oil Inlet (2) Gauge
(A) Oil Level is Acceptable Within This Range
1. Park the machine on a flat surface,
lower the implement and shut off
engine.
2. Check the fluid level on the fluid level
dipstick.If the level is too low,add new
oil to the prescribed level at the oil inlet.
(See "LUBRICANTS" in Maintenance
Section)
IMPORTANT
If oil level is low, do not run en-
gine.

CHECKING ENGINE OIL LEVEL

C86O603A
(1) Oil Inlet
(A) Oil Level is Acceptable Within this Range
IMPORTANT
When using an oil of different
maker or viscosity from the pre-
vious one, remove all of the old
oil. Never mix two different types
of oil.
Never run engine is the oil level is
low.
To avoid personal injury:
Be sure to stop the engine be-
fore checking the oil level.
1. Park the machine on a flat surface.
2. Check engine oil before starting the
engine or 5 minutes or more after the
engine has stopped.
3. To check the oil level, draw out the
dipstick, wipe it clean, replace it, and
C86O604A
draw it out again. Check to see that
the oil level lies between the two
(2) Dipstick
notches. If the level is too low, add
new oil to the prescribed level at the
oil inlet.
(See "LUBRICANTS" in Maintenance
Section)
CAUTION