Nexcom ICES 670 Series User Manual page 33

Chapter 3: BIOS Setup
SATA Mode Selection
Configures the SATA mode.
IDE This option configures the Serial ATA drives as Parallel ATA
physical storage device
AHCI This option configures the Serial ATA drives to use AHCI
(Advanced Host Controller Interface). AHCI allows the storage
driver to enable the advanced Serial ATA features which will
increase storage performance.
RAID This option allows you to create RAID or Intel Matrix Storage
configuration on Serial ATA devices.
Copyright © 2020 NEXCOM International Co., Ltd. All Rights Reserved.
AMT Configuration
This section is used to configure Active Management Technology (AMT)
options.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Advanced
Intel AMT
Un-Configure ME
Disable ME
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Intel AMT
®
Enables or disables Intel ® Active Management Technology.
Un-Configure ME
Enables or disables Un-configure ME without password.
Disable ME
Set ME to Soft Temporary Disabled.
20
[Enabled]
Enable/Disable Intel (R) Active
Mangement Technology BIOS
[Disabled]
Extension.
[Disabled]
Note: iAMT H/W is always
enabled.
This option just controls the
BIOS extension execution. If
enabled, this requires addtional
firmware in the SPI device.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
ICES 670 User Manual