Phocos Any-Grid Series User And Installation Manual page 29

Enter the interface and edit the currency
type and cash through "UP" or "DOWN".
Then press "ENTER" to get to the next line.
After editing the four digits, press "ENTER"
Setup Cash
to save and press "ESC" to exit.
The currency types include EUR, POD, CNY
and USD.
Enter the interface and edit the date and
time through "UP" or "DOWN". And then
Setup Date /
press "ENTER" again to get to the next line.
Time
After editing the four digits, press "ENTER"
to save and press "ESC" to exit.
Enter the interface and edit the language
through "UP" or "DOWN". Then press
"ENTER" to save and press "ESC" to exit.
Language
The default language is English.
Enter the interface and select country
through "UP" or "DOWN". Then press
Select
"ENTER" to save and press "ESC" to exit.
Country
The DC input mode includes
"independent" and "parallel":
"independent" mode means the MPPTs A
and B track independently of each other (if
there are two MPPTs); "parallel" mode
means the MPPTs A and B track in parallel
as one single large MPPT
The default mode is "independent".
Setup Mode
The input mode setting is invisible if the
inverter is in power generation. It is only
available during DC power on and AC
power off.
Press "UP" or "DOWN" to select the setting
mode and press "ENTER" to save the
setting or "ESC" to return.
Enter the interface and edit the user period
through "UP" or "DOWN". And then press
"ENTER" again to reach the next digit. After
editing, press "ENTER" to save and press
"ESC" to exit.
User Period
The set time and date need to be later than
the system setting, and the start time
needs to be earlier than the end time.
The setting date and time is used for the
statistical information.
www.phocos.com 28 | P a g e