Phocos Any-Grid Series User And Installation Manual page 28

Parameter settings:
Setting Item LCD Screen View
RS485
Address
User
Password
www.phocos.com
Instructions
Enter into the interface and edit the data
through "UP" or "DOWN". And then press
"ENTER" again to the next bit. After editing
the three bits, press "ENT" to save the
edition and press "ESC" to exit.
Enter into the interface and edit the data
through "UP" or "DOWN". And then press
"ENTER" again to go to the next digit. After
editing the four digits, press "ENTER" to
save and press "ESC" to exit.
The default password is "0000". The user
can enter the setting interface without a
password. If the password is not "0000",
the user can enter the setting interface
only with the correct password.
27 | P a g e