Setting Up The Tonometer; Installing Or Changing The Battery; Turning The Tonometer On; Loading The Probe - Icare TA022 Instruction Manual

www.icaretonometer.com
TOP PARTS (Figure 2)
6. Measurement button
7. Forehead support position indicator
SIDE PARTS (Figure 3)
8. Forehead support adjustment wheel
9. Cheek support adjustment wheel
BOTTOM PARTS (Figure 4)
10. Battery cover
11. Silicone lid (USB cover)
12. Type label
BACK PANEL (Figure 5)
13. Measurement button
14. LOAD light
15. MEASURE light
16. REPEAT light
17. DONE light
18. SERVICE light
19. BATTERY light
20. POWER button

10. SETTING UP THE TONOMETER

Setting up your Icare HOME tonometer is easy, with few steps. The following
subchapters describe how you get started.

10.1 INSTALLING OR CHANGING THE BATTERY

Lift the silicone lid that protects the USB port and keeps the battery
compartment cover in place. Open the battery compartment cover by pressing
the silicone lid slightly and sliding the battery compartment cover as shown in
the Figure 6.
1. Silicone lid
2. Battery cover
Insert two CR123A lithium batteries in the correct order: (+) end upwards
as shown in the figure left. Close the cover firmly and press the silicone lid in
place to cover the USB port.

10.2 TURNING THE TONOMETER ON

Press the power button (20) to turn the tonometer on. The lights (14-19) are
turned on briefly. Following a brief pause, the Load light flashes on the back
panel to remind the user to load the single-use probe into the tonometer
prior to measurement.

10.3 LOADING THE PROBE

The Icare HOME tonometer uses single-use probes that are packed in a
plastic tube and wrapped in blister packs as shown in the Figures 8 and 9.
To load the probe:
1. Unwrap the probe (Figure 10).
2. Remove the lid of the probe container as shown in the Figure 11.
Point the tonometer upward.
3. Drop the probe into the probe base by turning the probe container
upside down as shown in the Figure 12.
4. Press the measurement button briefly (1 second) to activate the probe
(Figure 13).
5. The probe moves rapidly back and forth (Figure 14).
6. If the green Measure light flashes, the probe is loaded correctly and
ready for measurement (Figure 15).

11. USING THE TONOMETER

11.1 CHOOSING THE MEASUREMENT MODE

The tonometer can operate in two modes:
Series mode
In the series mode, keeping the button pressed down (see Figure 16) initiates
the measurement function, and the tonometer takes six rapid measurements
5