Instructions For Use (User) - Otto Bock Genium Protector 4X880 Series Instructions For Use Manual

5 Scope of Delivery
Quant­ Product
ity
1 pc. Genium Protector
1 pc. Upper closure
1 pc. Lengthwise closure
1 pc. Foot cuff
1 pc.

Instructions for use (user)

6 Handling
INFORMATION
Removing the foot cuff from the prosthetic foot is not possible. The foot cuff stays on the pros­
thetic foot even when the protector is not being used.
6.1 Protector Installation
1) Open or remove the closures.
2) Spread open the protector and apply it to the knee joint.
→ Thread the protector into the foot cuff from the front (see fig. 1).
→ The retainers of the protector have to engage on the frame element of the knee joint (see
fig. 2).
3) Fasten the upper closure.
→ The retainer of the upper closure has to engage on the frame element of the knee joint
(see fig. 3).
→ Slightly squeeze the protector together with both hands.
→ The upper closure has to be pushed down after engaging.
→ Push down the upper closure with the thumb (see fig. 4).
4) Fasten the lengthwise closure (see fig. 5).
NOTICE
Loss of stability due to inadequately installed retainers
No hold of the protector on the knee joint.
► Ensure that all retainers and closures are properly engaged and/or fastened.
6.2 Removing the Protector
1) Pull down the textile material of the foot cuff until the protector is exposed.
2) Open or remove the closures.
3) Spread open the protector and remove it from the knee joint.
4) Fasten the two closures after removing the protector.
7 Maintenance
► During the standard inspection of the prosthesis components, also inspect the product.
7.1 Cleaning and Care
NOTICE
Improper product care
Damage to the product due to the use of incorrect cleaning agents.
10 | Ottobock
Article number
4X880=*
-
-
4P880=*
646D298