AMP Research Power Step Installation Manual page 6

For jeep wrangler unlimited (jk) 2007–2015 2-door

Hide thumbs Also See for Power Step:

Remove passenger side front door sill.

Posi-Tap™ instructions

Insert

Strip 3/8"

Remove driver side door sill and pull up

carpet.

www.amp-research.com

Tighten

Insert and

Tighten

Lift carpet. Slit rubber grommet and pass trig-

ger wires through grommet in floor into pas-

senger compartment.

Use Posi-Tap connectors to connect Power Step trigger

wires to like colored wires in the factory system as shown:

Violet/White wire in loom coming from front door, Violet/

Yellow and Violet/Grey are not used tape off ends. Note:

For door removal attach posi tap on chassis side of

door harness.

Route Violet wire under carpet to driver side door sill

and connect to violet wire coming from door as shown.

Note: For door removal attach posi tap on chassis

side of door harness.

6/8

IM75121 rev 02.24.15

Need help?

Do you have a question about the Power Step and is the answer not in the manual?

Powerstep 75121-01a