AMP Research Power Step Installation Manual page 5

A M P R E S E A R C H P O W E R S T E P – J E E P W R A N G L E R ( J K )
Mount step extrusion to linkage assemblies.
Line up t-nuts in step assembly with slots in
lower mounts of linkage assemblies. Fasten
loosely to allow for adjustments.
7
10
Tighten 4 socket cap screws with 3/16" allen wrench.
Torque to 10 ft-lbs. (13.5 N-m)
1
10
9
Install controller on passenger side at firewall.
Secure with 11" cable ties. Connect Red wire
to positive battery terminal and Black wire to
negative battery terminal.
7
10 11
www.amp-research.com www.amp-research.com
1
10
8
Line up rear of step extrusion with rear fender
well.
8
Remove fuse from Power Step wire harness.
10
Route longest leg of wire harness across fire wall
to driver side and under vehicle outside of frame
rail. Route shortest leg of wire harness down fire
wall and outside of frame rail on passenger side.
7
12
5/8 5/8
8
8
IM75121 rev 02.24.15
+