Table of Contents
Advertisement
>
Use the TUNING/SKIP buttons (6, 7) to select one of the available languages
and confirm with ENTER/STOP/SLEEP (8).
15.7 Software version
>
Select DAB+ or FM radio mode.
>
Open the main menu by holding down the INFO/MENU/MEMORY button (5)
and use the TUNING/SKIP buttons (6, 7) to select the <SW Version> item.
Press the ENTER/STOP/SLEEP button (8).
>
The software version currently installed will now be displayed.
15.8 Factory settings
If you want to reset the DIGITRADIO 1990 to the delivery status, proceed as follows:
Doing so will delete all settings, stations and favourites.
1.
Select DAB+ radio mode.
2.
Open the CD compartment cover.
3.
Hold down the Folder +/2 button (16) on the front until [Restart] appears in
the display.
16 Cleaning the device
WARNING Electric shock!
To prevent the risk of an electric shock, you must not clean the device using a
wet cloth or under running water. Before cleaning, disconnect from the mains
and remove any inserted batteries.
You may not use scouring pads, scouring powder and solvents such as alcohol
or petrol.
>
Clean the housing using a soft, moist cloth.
17 Troubleshooting
17.1 Problems with the radio
Symptom
No radio stations are being received.
No DAB signal is being received.
Possible cause/remedy
Change the orientation of the antenna
if necessary. Check whether DAB
or FM mode has been selected.
Check whether DAB reception is possible
in your region. Realign the antenna. Try
to receive other stations.
29
Advertisement
Table of Contents
