Other Functions; Sleep Timer; Alarm Function - TechniSat DIGITRADIO 1990 Instruction Manual

15 Other functions

15.1 Sleep timer

The sleep timer automatically switches the DIGITRADIO 1990 to standby after a
specified time.
> Press and hold the ENTER/STOP/SLEEP button (8) until [SLEEP] appears in
the display.
> You can use the TUNING/SKIP buttons (6, 7) to enter a period after which the
DIGITRADIO 1990 should switch off.
> Confirm by pressing the ENTER/STOP/SLEEP button (8).
When the sleep timer is enabled, an "S" appears in the display next to the
time.
> Select Sleep Timer > Off to switch off an active sleep timer.

15.2 Alarm function

The DIGITRADIO 1990 has an internal alarm that you can program.
The alarm is only available when the DIGITRADIO 1990 is connected to the
mains. The alarm will not work in battery mode.
> Switch the DIGITRADIO 1990 to standby mode.
> Press the DIMMER/TIMER button (4). Timer On appears in the display and the
hour numbers flash.
> Enter the hours using the TUNING/SKIP buttons (6, 7) and confirm with
DIMMER/TIMER (4). The minutes now flash.
> Set the minutes using the TUNING/SKIP buttons (6, 7) and confirm with
DIMMER/TIMER (4).
> You then need to enter the Timer Off time as described.
> You then enter the source. Use the TUNING/SKIP buttons (6, 7) to select one
of the available playback sources and confirm using the DIMMER/TIMER button
(4) again.
> Finally, set the alarm sound volume. Select the volume using the TUNING/SKIP
buttons (6, 7) and save the alarm using the DIMMER/TIMER button (4).
The alarm is now active and a clock icon appears in the display. To switch off
an alarm, hold down the DIMMER/TIMER button (4) until the clock icon is no
longer displayed.
If DAB+ or FM is selected as the alarm sound, the last-set station is always
played.
27