Advanced Network Settings; Set-Up Wizard; Auto Standby; Brightness - TechniSat VIOLA 2 C IR Instruction Manual

10.2.2

Advanced network settings

To find out more about the current connection select Display settings.
Select Manual setting if you know your network parameters and would like to
configure them manually. Take note of the instructions on the display.
Select Delete network profile to delete connections no longer required or
select Reset settings to delete all network settings.
If the network connection should be retained in standby, select Enable
Network Connection in Standby > Yes. However, doing so will increase the
power consumption.
10.3

Set-up wizard

On first switching on and after a factory settings reset, the set-up wizard is
automatically launched.
> First confirm the data protection stipulations by pressing the Selection knob.
> Then use the Selection knob to select whether the set-up wizard should be
carried out (YES) or not (NO).
If you select NO, the wizard closes and you need to perform the required
settings manually.
After selecting YES you will be guided in steps through the settings.
> Under Time format, select the desired display format for the time display
(Section 10.1.3).
> During the next step you must select via which source the time is to be
synchronised (for more information refer to Section 10.1.2).
> Then you can select whether the WLAN connection should also be maintained
in standby (YES) or whether it should be switched off (NO).
> You can then set up a WLAN network connection. For more details, see
Section 10.2.
> Press the Selection knob to close the wizard when Set-up Wizard
Completed appears in the display.
58
10.4

Auto Standby

> By turning and pressing the Selection knob, in System settings > Auto
Standby, select whether the radio should automatically switch to Standby
after (2 hours, 4 hours, 5 hours or 6 hours) if it has not been used in the
meantime, or switch the function off.
10.5

Brightness

Under System settings > Brightness you can set the brightness of the display
for operation to High, Medium, or Low, and for Standby to Medium or Low. For
Standby, you also have the facility of setting the time after which the brightness
should be dimmed to the selected brightness.
> The settings are carried out by turning and pressing the Selection knob.
10.6

Language

> Under System settings > Language, select the desired system language by
turning and pressing the Selection knob.
10.7

Factory settings

> Select System Settings > Factory settings to reset the Viola 2 C IR to its
delivery status.
Calling up the factory settings resets all changes and settings you have made!
10.8

Displaying the software version

> To display the installed software version, call up System settings > Info with
the Selection knob.
DE
EN
59