Table of Contents
Advertisement
15.3 Equaliser
The DIGITRADIO 1990 has multiple sound presets.
>
Hold down the EQ button (19).
>
Use the TUNING/SKIP buttons (6, 7) to select from the CLASSIC - JAZZ - ROCK
- POP - FLAT sound curves.
>
Press the ENTER/STOP/SLEEP button (8) to confirm the setting.
15.4 Dimmer
The display brightness can be adjusted in 4 steps.
>
Switch the DIGITRADIO 1990 on.
>
Press the DIMMER/TIMER button (4) multiple times to scroll through the
various brightness settings (Bright, Medium, Dark and Off).
The same brightness settings apply in standby mode as in normal operation.
In battery mode, the display is always dimmed and only becomes brighter by
pressing a button. It is dimmed again after 10 seconds, to save battery power.
15.5 Setting the time
The DIGITRADIO 1990 basically derives the current time from the DAB+ signal. If you
are operating the device for the first time, it may take some time until the clock is
synchronised. If you want to set the time manually (if no DAB+ signal is available),
please proceed as follows:
>
Switch the DIGITRADIO 1990 to standby mode.
>
Briefly press the MODE/CLOCK button (3).
>
Use the TUNING/SKIP buttons (6, 7) to enter the time format. Press the
MODE/CLOCK button (3) to accept the setting.
>
The hour numbers now flash. Use the TUNING/SKIP buttons (6, 7) to enter the
hours and confirm with MODE/CLOCK (3).
>
The minute numbers then flash. Use the TUNING/SKIP buttons (6, 7) to enter
the minutes and confirm with MODE/CLOCK (3). The time is saved.
15.6 Language
>
Select DAB+ or FM radio mode.
>
Open the main menu by holding down the INFO/MENU/MEMORY button (5)
and use the TUNING/SKIP buttons (6, 7) to select the <Language> item. Press
the ENTER/STOP/SLEEP button (8).
28
Advertisement
Table of Contents
