Attach The Rack-Mount Brackets-Chassis Front-Mounted; Rack-Mount The Router - Cisco 7304 Quick Start Manual

4

Rack-Mount the Router

This section provides information for rack-mounting the router.
Attach the Rack-Mount Brackets—Chassis Front-Mounted
Figure 4 Attaching the Rack-Mount Brackets to the Front of the Chassis
9K-1 0C4
8
TX
OIR RX
STAT US
1-PO RT
OC4 8 POS
w/ SMS
R
9K- NSE
100
DISK 0
COMP ACT
FLAS H
RESE T
CONS OLE
AUX
PRIM ARY
GE 0
SECO NDAR
SYST EM-U
P Y
NET WOR
GE 1
K SER VICE
S ENG INE
100
RX PE 0
TX
LINK
RX
TX
LINK
LINK
1 Rack-mount bracket
The rack-mount brackets ship installed on the router. These instructions are provided if you want to change the position of the
brackets or reattach them. Depending on how the rack-mount brackets are attached to the chassis, the chassis either protrudes
from the rack or is recessed in the rack.
Step 1 Locate the rack-mount and cable-management brackets and screws and a Number 2 Phillips screwdriver.
Step 2 Align the rack-mount bracket to the side of the router. Depending on which set of rack-mount bracket holes you choose
to use to attach the rack-mount bracket to the router, the chassis will either be recessed in the rack or protrude from
the rack.
Step 3 Insert and tighten the two screws. Repeat Step 1 and Step 2 on the other side of the router.
To install the cable-management brackets, see the
Step 4
are not installing the cable-management brackets, skip to the
"Two-Post Rack Installation" section on page 13
10
9K- 40C
3/P OS-
MM
OIR OIR
STAT US STAT US 0
1
4-PO RT
OC3 POS 2
w/ MM 3
CAR RIER
/
ALA RM
ACT IVE/
LOO PBA
CK
1 2
2
Eight 8-18 x .37-inch screws—19-inch rack
Eight 8 x .755-inch screws—21-23-inch rack
"Attach the Cable-Management Brackets" section on page
"Four-Post Rack Installation" section on page 12
for rack-mount instructions.
11. If you
or the