Install And Remove Qsfp Transceiver Modules - Cisco 8800 Series Hardware Installation Manual

Install and Remove QSFP Transceiver Modules

Caution
To comply with GR-1089 intrabuilding, lightning immunity requirements, you must use a foil twisted-pair
(FTP) cable that is properly grounded at both ends.
The following figure shows the RJ-45 connector.
Figure 69: RJ-45 Connector
1
Install and Remove QSFP Transceiver Modules
This section provides the installation, cabling, and removal instructions for the Quad Small Form-Factor
Pluggable transceiver modules. Refer to the
on optical transceivers.
The following figure shows a 400-Gigabit QSFP-DD optical transceiver.
Figure 70: 400-Gigabit QSFP-DD Transceiver Module
1
3
Hardware Installation Guide for Cisco 8800 Series Routers
80
Pin 1
Pull-tab
Electrical connection to
the module circuitry
2 Pin 8
Cisco Optical Transceiver Handling Guide
2
Connect Router to the Network
for additional details
QSFP-DD transceiver
body