Cisco NCS 1004 Hardware Installation Manual page 60

Remove and Replace Controller
For replacing the PSU, see
Remove and Replace Controller
This procedure has details about removing and replacing the controller.
Step 1
Using a Torx screwdriver, unfasten the two screws on the controller.
Step 2 Using the handle with one hand, and supporting the controller with the other, gently remove the controller from the slot.
Figure 55: Removing the Controller
What to do next
For replacing the controller, see
Hardware Installation Guide for Cisco NCS 1004
58
Power Supply.
Install Controller
Remove and Replace Cisco NCS 1004 Modules
.