Cisco NCS 1004 Hardware Installation Manual page 25

Install Cisco NCS 1004
Caution
The sliding rail must be used only for first chassis positioning. The chassis must be fixed with screws on the
front side.
Caution
Use only the fastening hardware provided with Cisco NCS 1004 to prevent loosening, deterioration, and
electromechanical corrosion of the hardware and joined material.
Before you begin
Ensure the rack is compatible. See the
Step 1 Attach the left and right mounting brackets to the chassis using the screws (48-2029-01) and tighten them to a torque
value of 1.5 N-m.
The left and right brackets have been marked accordingly.
Figure 22: Fixing the Brackets
1 Right Bracket (700-116388-01)
2 Screws used for brackets
3 Left Bracket (700-116386-01)
Step 2 Install the four post slider or two post slider on the rack.
a) Install Two Post Slider into an EIA/ANSI Rack
b) Install Four Post Slider into an EIA/ ANSI Rack
Rack Compatibility section.
Hardware Installation Guide for Cisco NCS 1004
Install NCS 1004 on an EIA/ANSI/ ETSI Rack
23