Cisco NCS 1004 Hardware Installation Manual page 44

Connect DC Power to NCS 1004
Figure 37: Installing a PSU
Connect DC Power to NCS 1004
Caution
NCS 1004 relies on the protective devices in the building installation to protect against short circuit, overcurrent,
and ground faults. Ensure that the protective devices comply with local and national electrical codes.
Figure 38: Rating Label for DC Power
Step 1
Verify that the correct fuse panel is installed in the top mounting space.
Step 2 Measure and cut the cables as needed to reach NCS 1004 from the fuse panel.
Step 3
Dress the power according to local practice.
Step 4 Connect the office battery and return cables according to the fuse panel engineering specifications.
Hardware Installation Guide for Cisco NCS 1004
42
Install Cisco NCS 1004 Modules